Installation Guides

Make sure the area you wish to install the Tough Route onto is clean and dry. Ensure there are no paint flakes or other loose materials on the floor. Do not use methylated spirits, petrol, lighter fluid, or similar to clean the surface, as these leave behind a residue, which may prevent the markings sticking to the floor.

Clear the area, where the matting is to be fitted – Sweep up any dirt or dust and move any large portable items out of the way – e.g. portable heaters, bins, etc… Lay down the first Dura-Link tile where you are wanting the matting to start. Clip together the matting sections, using a rubber mallet to connect

Clear the area, where the matting is to be fitted – Sweep up any dirt or dust and move any large portable items out of the way. Clean any grease or fluids from the floor ensuring it is dry before commencing installation Place the Clean-Start Forklift Mat face down with the rubber backing side up. Tape along all

Or read more below – Clear the area where the matting is to be installed – Sweep up any dirt or dust and move any large portable items out of the way – e.g. portable heaters, bins, etc… Starting at where you are wanting the matting to end, lay down one Work Deck tile down, with the connecting

Clear the area, where the matting is to be fitted – Sweep up any dirt or dust and move any large portable items out of the way – e.g. portable heaters, bins, etc… Lay down the first Endura tile where you are wanting the matting to start. Clip together the Endura sections, using a rubber mallet to connect

Clear the area, where the matting is to be fitted – Sweep up any dirt or dust and move any large portable items out of the way – e.g. portable heaters, bins, etc… Lay down each Bubble mat in the workplace position. If the Bubble mat is a large Bubble mat Bespoke, lay the matting out carefully into